Worktop-Oil, 20ml

• GISCODE Ö10+
• LFGB-tested (food-safe)
• DIN 71-3 (Safety of children's toys)
• DIN 53160 (resistant to saliva and perspiration)
• Cobalt-free & oxime-free, FREE from formaldehyde, aromatics, biocides, preservatives

PREPARATION: 

✔ Sand the wood surface professionally: Final sanding for furniture with a maximum grit of 180.
✔ Wood moisture: 8–12 %.
✔ Substrate: Firm, dry, clean, non-slip, sound and free from release agents.
✔ Material application: Apply at room temperature.

OPTIONAL STEPS

➜ Higher wear or faster curing: OLI-NATURA Hardener add in the ratio 5:1 The mixture remains workable for 3 hours.

➜ Tannin-rich woods (e.g. oak): Before oiling treat with PreOilCleaner .

GOOD TO KNOW:

• When using OLI-NATURA Antique Reactive Stain the surface must not previously be wetted or cleaned with PreOilCleaner.
  
• 2K application: Mix with OLI-NATURA Hardener (5:1) Pot life: approx. 2–3 hours Curing time is reduced by 2–3 days. Coverage:.
• Depending on wood species, sanding and absorbency . Excess oil as well aslow temperatures and high humidity delay drying. APPLICATION:

Shake/stir the container well.

1. (Optional)
   
2. 2K application : Thoroughly mix 5 parts oil with 1 part hardener.Apply a small amount of oil thinly with a rubber squeegee or spatula. Then carefully work it in by hand or with an orbital sander using a beige pad. Alternatively, the oil can be applied and worked in directly with the beige pad. Apply more oil to dry areas.
   
3. Allow the oil to penetrate for 15–30 minutes. 
4. Polish off the excess oil by hand or with an orbital sander using a white polishing pad until the surface is saturated and no longer appears wet. If there is too much oil on the surface, remove the excess with a cloth before polishing. The surface must not feel sticky.
5. If needed, polish again the next day with a white polishing pad and 5–10 ml/m² of oil.
   
6. Coverage: 
   
7. 1 coat, depending on the absorbency of the substrate, 20-40 g/m² per coat (25-50 m²/l)

Drying: Depending on humidity/temperature – dust-dry in 1.5-2 hours, fully cured in 5-7 days; the 2K version reduces this by 2-3 days. During this time, handle gently, protect from water and do not clean with a damp cloth. 

Storage: Unopened in the original container, shelf life of approx. 36 months.

Clean work tools: OLI-NATURA brush cleaner or oil thinner.

⚠ Safety notice:

Oil-soaked cloths and rags can self-ignite due to heat buildup
. After use, therefore store airtight in a metal container or immerse in water. Nach Gebrauch daher luftdicht in einem Metallbehälter aufbewahren oder in Wasser tauchen. 

Low maintenance - great advantage

A common misconception: Oiled surfaces are considered high-maintenance. In fact, they are particularly easy to maintain - simple re-oiling refreshes them again and again, and scratches can be repaired precisely.

Freshly oiled wood is sensitive to water during the first few days. Until it has fully cured, contact with liquids should be avoided and spilled water should be wiped up immediately.

Here are some care tips:

Routine cleaning

• Dust regularly with a soft cotton cloth.
• Remove light dirt with a slightly damp cloth.
• Clean stubborn dirt with OLI-NATURA wood soap - do not use all-purpose cleaners, as they dry out the wood.

Protection from moisture & heat

• Do not leave standing liquid on the surface.
• Wipe up spilled drinks immediately.
• Place hot pots only on trivets.

Refreshing & care

• Re-oil as needed - when the wood appears less water-repellent or looks dry.
• To refresh the protective finish, use OLI-NATURA wood care oil, OLI-NATURA Refresher, or care with itself Apply a thin layer with a cotton cloth and massage in evenly.

Simple repairs

• Fine scratches can be removed by lightly sanding and re-oiling.
• Smooth damaged areas partially with sandpaper and treat them with the original oil.
• Differences in color will even out over time.

With minimal effort, oiled wood remains beautiful and resilient for a long time.

The product is not subject to labeling requirements and, pursuant to Regulation (EC) No. 1272/2008, is not classified as hazardous. Not classified as dangerous goods; no GHS pictograms or signal words are required.

Oil-soaked rags/pads can spontaneously ignite due to heat accumulation! Therefore, clean them immediately after use or store them under water. P102 Keep out of reach of children. 

Does Worktop-Oil change the color of the wood?

Yes, although the oil is not pigmented , it enhances the natural color of the wood and emphasizes the grain. This effect is referred to in technical jargon as the wet-look effect or color enhancement .

Is the oil suitable for wood with epoxy resin inlays?

Yes, thanks to its high transparency, it is ideal for combinations of wood and epoxy resin. However, for this application, we recommend using OLI-NATURA Hardener (hardener), so that the oil anchors itself better in the wood and adheres reliably to the epoxy resin.

Can I treat wooden sinks and washstands with Worktop-Oil?

Yes, for this application, we recommend using it with OLI-NATURA Hardener (hardener), to increase the cross-linking density, water resistance, and cream resistance. In addition, the surface should be wetted with PreOilCleaner before oiling to optimize absorption and protective performance.

Can I apply Worktop-Oil with a brush?

No, applying it with a brush or roller is not recommended because the oil is very viscous and is quickly applied too thickly . Applying it with a spatulais more effective for achieving a thin, even layer. The oil is then massaged in with a pad and, after a short application time,.